UFiber UF-Instant
Hardware Specifications
| Vendor/Brand | UFiber |
| Model | UFiber UF-Instant |
| Chipset | Realtek RTL9601CI |
| Flash | 16 MB |
| RAM | 64 MB |
| System | Linux (Luna SDK) |
| HSGMII | No |
| Optics | SC/APC |
| IP address | |
| Web Gui | ✅ |
| SSH | ✅ |
| Telnet | |
| Serial | |
| Form Factor | miniONT SFP |
Firmware is interchangeable with:
Info The UFiber UF-Instant can be used as universal GPON stick with V2801F rootfs, but only with stock UF kernel (4.3.1/4.4.2): needed for Laser controller.
List of partitions
| dev | size | erasesize | name |
|---|---|---|---|
| mtd0 | 00040000 | 00001000 | “boot” |
| mtd1 | 00002000 | 00001000 | “env” |
| mtd2 | 00002000 | 00001000 | “env2” |
| mtd3 | 0003c000 | 00001000 | “config” |
| mtd4 | 00300000 | 00001000 | “k0” |
| mtd5 | 004b0000 | 00001000 | “r0” |
| mtd6 | 00300000 | 00001000 | “k1” |
| mtd7 | 004b0000 | 00001000 | “r1” |
| mtd8 | 00010000 | 00001000 | “hw” |
| mtd9 | 00010000 | 00001000 | “sec” |
Know Bugs
VLAN swap issue (MEID 171), auto-sensing mode to switch between SGMII/HiSGMII
You should use the VID/VLAN shown by executing the command omcicli mib get 84 via telnet to bring up PPPoE